Printing from CorelDRAW
Right click on file → “Open with program” → Choose “CorelDRAW”Right click on file → “Open with program” → Choose “CorelDRAW”
For the pop-up, choose “curved line”
Except for the layer that you will print, you need to click the “Print/do not print” printer icon and set everything up
From Properties → Confirm color and width of line with the “Pen icon” at the bottom right of the screen
Go to “File” on the Menu Bar, and click “Print”
Confirm if the designated X is “VLS2.30”
Click “Properties”
Settings for materials with specialized software
Select the “Material Database” tab on the left side of the screen
Select material from “Category”
Select thickness and materials → if not available it will be necessary to create the setting, so please consult the staff
Once finished with selection, select “Manual Control”
Confirm that the “Z-Axis” column is “OFF” → If it is ON, the table will operate on the set thickness, but at present, this function is not used.
When “ON”, put the processing settings into selection mode, and set the A area on the screen to “OFF” → Click the “Set” → “Apply” → “OK”
After pressing the “Print” button, click the “ULS” button at the lower right side of the monitor to move to the ULS screen
Press the “Power” button at the top right of the screen and turn the processing machine
Setting focus point for processing machine
！WARNING！Do not consecutively press the lift button for the processing machine! The machine will start to move quickly and be unable to stop, and doing so will be cause for malfunctions
Place materials on the metal fittings of the table
Confirm that the materials and the lighting head aren’t touching, and move the head over the materials using the “Focus View” mode
Position the jig, and adjust the height using the table’s lift button
You can also raise the table by using the button on the ULS screen
Make sure to completely close the lid of the operation area → If not shut properly, it will touch parts of the processing machine
However, if you put too much stress on the processing rails, they will bend, so please be careful of that
Confirming processing position & material position
Select “Focus View” from the pull-down menu on the USL screen
Set the cursor to the position of the processing data, click, and the head will move
When moving the processing data, select “Relocate View”
You may either drag & drop the data to your desired location, or you may input coordinates
Turn on Air Assist & Dust Collector
Turn on the power to the Air Assist on the desk for the PC monitor
Turn the on the power to the Dust Collector
Start Processing
Press the “Start” button for the ULS, and begin processing
If, during processing, the materials start burning, etc., open the lid to the processing machine, do a “force-quit” and put out the flame
When you must stop for whatever reason, use the temporary stop button → There are instances when the machine does not recover
Remove items and clean
Cleaning method (a write-up will be written at a later date)
